How to Get In and Out of a Car Wearing a Lehenga: A Wedding-Day Guide
Share

Knowing how to get in and out of a car wearing a lehenga can save the skirt from crushed pleats, caught embroidery and a dragged hem. The safest method is to sit first, bring the skirt onto your lap, then move your feet in together. When getting out, reverse the sequence and stand only after the skirt is clear.
Weddingwear in 2026–27 is increasingly discussed in terms of movement as well as appearance. A lehenga may look beautiful in a still photograph, but its flare, can-can and dupatta need to work in real situations such as a narrow car door, a crowded drop-off or a long drive between venues.
Prepare the lehenga before the car arrives
- Check the hem with the exact footwear. The skirt should clear the floor when you stand naturally. Do not rely on a trial done barefoot if you will wear heels.
- Keep the dupatta under control. Secure it at the shoulder or blouse seam with a fabric-safe pin, leaving no loose end near the door hinge.
- Choose the side of the car with more room. Ask the driver to stop where the door can open fully and you can stand without stepping into traffic.
- Ask one person to manage the skirt. A companion can lift the outer layer while you sit, but should not pull the waistband or embroidery.
Step-by-step: getting into the car
- Stand beside the open door and gather the skirt lightly at both sides, just above the hem. Do not lift it by a single embroidered panel or latkan.
- Turn so your back is toward the seat, then lower yourself onto the seat first. Keep your knees together as you sit.
- Bring the skirt across your lap in a wide, loose fold. Do not stuff the can-can underneath your thighs; that can distort the volume and crease the inner layers.
- Move both feet into the footwell together. Check that no border, tassel or dupatta edge is caught outside the door.
- Before closing the door, make sure the skirt is inside the cabin and away from the latch.
Step-by-step: getting out
Open the door fully, move both feet to the ground and keep the skirt gathered above the hem. Slide forward to the edge of the seat, stand with support if needed, and let the skirt fall naturally only after the hem is clear of the sill. Smooth the pleats with your hands rather than tugging at the waist.
What to test at the final fitting
Practise the full movement in the outfit: sit, bring your feet in, turn slightly, stand and take three steps. Check that the waistband does not roll, the blouse does not pull at the back and the skirt does not catch under your shoes. A very full skirt may need a little more room in a compact car.
For a visual example of a voluminous butterfly-net style, see the Blue Butterfly Net Wedding Lehenga Choli with Sequin & Cording Embroidery. Its listing describes a semi-stitched skirt with a 42-inch length, 3-metre-plus flare and micro-cotton inner with can-can and canvas. Those construction details make a seated trial especially worthwhile. Check the product page for current availability and full specifications.
Quick wedding-day checklist
- Wear the shoes used for the final hem measurement.
- Keep the dupatta and tassels clear of the door.
- Sit first; gather the skirt over your lap; move both feet together.
- Never pull the skirt by a single embroidered motif.
- After getting out, let the flare settle before walking.
For more preparation, read our lehenga length guide and destination-wedding packing guide.